查找地点
有关时间、上门服务和预约查找地点
有关时间、上门服务和预约If the patient's hematocrit exceeds 55%, the volume of citrate in the collection tube must be adjusted. Refer to Coagulation Collection Procedures for directions.
2 - 3 days
Turnaround time is defined as the usual number of days from the date of pickup of a specimen for testing to when the result is released to the ordering provider. In some cases, additional time should be allowed for additional confirmatory or additional reflex tests. Testing schedules may vary.
For more information, please view the literature below.
Procedures for Hemostasis and Thrombosis: A Clinical Test Compendium
Plasma, frozen
1 mL
Blue-top (sodium citrate) tube
Blood should be collected in a blue-top tube containing 3.2% buffered sodium citrate.1 Evacuated collection tubes must be filled to completion to ensure a proper blood-to-anticoagulant ratio.2,3 The sample should be mixed immediately by gentle inversion at least six times to ensure adequate mixing of the anticoagulant with the blood. A discard tube is not required prior to collection of coagulation samples unless the sample is collected using a winged (butterfly) collection system. With a winged blood collection set a discard tube should be drawn first to account for the dead space of the tubing and prevent under-filling of the evacuated tube.4,5 When noncitrate tubes are collected for other tests, collect sterile and nonadditive (red-top) tubes prior to citrate (blue-top) tubes. Any tube containing an alternative anticoagulant should be collected after the blue-top tube. Gel-barrier tubes and serum tubes with clot initiators should also be collected after the citrate tubes.
Please print and use the Volume Guide for Coagulation Testing to ensure proper draw volume.
Freeze.
Temperature | Period |
---|---|
Frozen | 28 days |
Freeze/thaw cycles | Stable x3 |
Ideally the patient should not be on anticoagulant therapy. Avoid warfarin (Coumadin®) therapy for two weeks prior to the test and heparin, direct Xa, and thrombin inhibitor therapies for about three days prior to testing.
Severe hemolysis; improper labeling; clotted specimen; specimen diluted with IV fluids; samples thawed in transit; improper sample type; sample out of stability
This test is used to evaluate an isolated prolonged PT or when there is prolongation of both the aPTT and PT and to document specific factor II deficiency.6-8
Direct Xa or thrombin inhibitor therapy may cause factitiously low results.
Factor II activity is determined utilizing a prothrombin time (PT)-based one-stage clotting time assay. Factor II-depleted plasma is used as the substrate, and the clotting time with the patient plasma is compared to the clotting time of normal pooled plasma.
Factor II is a 72-kilodalton vitamin K-dependent glycoprotein coagulation factor that is produced by the liver.6 Normal factor II plasma concentration is approximately 100 mg/mL and half-life is about 60 hours.6 Factor II activation occurs by both the extrinsic and intrinsic pathways. Factor II deficiency should be considered when a patient with bleeding history has both extended protime (PT) and activated partial thromboplastin time (aPTT). Inhibitors to factor II may develop in select patients with lupus anticoagulants and tends to occur more frequently in a pediatric population. These inhibitors bind factor II in plasma and clear the antibody-antigen complex resulting in a factor II deficiency and enhanced bleeding potential. A factor II Bethesda (inhibitor) assay is negative in this instance. The dilute Russell's viper venom time (dRVVT) will be prolonged in patients with factor II deficiency.7,8
Congenital factor II deficiency is rare (fewer than 100 cases have been reported) and is inherited as an autosomal recessive trait.6,7 This condition affects both males and females, and the prevalence of factor II deficiency is equal in all ethnic groups.6 A few cases of combined congenital factor II, VII, IX, and X deficiencies have been reported.6 Acquired deficiencies occur with significant hepatic dysfunction, with oral anticoagulant (coumarin) therapy, and in individuals with vitamin K deficiency.7,8 Diminished levels that can be associated with bleeding can be observed in some patients with lupus anticoagulants due to enhanced clearance of prothrombin/antibody complexes.6,7
Symptoms of factor II deficiency include easy bruising, hematoma formation, postsurgical hemorrhage, menorrhagia, epistaxis, and umbilical cord hemorrhage.6,7 Heterozygous individuals typically have factor II activities near 50% and are asymptomatic or have minor bleeding complications associated with trauma or surgery.7 Factor II plasma activity <30%, as can be observed in individuals with homozygous deficiency, may result in excessive bleeding following a traumatic event.6,8 Spontaneous bleeding or hemarthroses are rare but may occur in homozygotes with very low activity.6-8
Factor II activity in excess of 115% has been associated with an increased risk of thrombosis.6 The G20210A mutation in the prothrombin gene can be associated with increased plasma prothrombin levels.6,9 This polymorphism can be identified in 1% to 2% of the US population, but is highly race-dependent. This mutation is relatively uncommon in African Americans, Asians, and native Americans.9 A recent consensus conference of the College of American Pathologists on diagnostic issues in thrombophilia concluded that the prothrombin G20210A mutation is a significant risk factor of venous thromboembolism and should be considered in the initial evaluation of potential inherited thrombophilia.9
Order Code | Order Code Name | Order Loinc | Result Code | Result Code Name | UofM | Result LOINC |
---|---|---|---|---|---|---|
086231 | Factor II Activity | 3289-6 | 086231 | Factor II Activity | % | 3289-6 |
© 2021 Laboratory Corporation of America® Holdings and Lexi-Comp Inc. All Rights Reserved.
CPT Statement/Profile Statement
The LOINC® codes are copyright © 1994-2021, Regenstrief Institute, Inc. and the Logical Observation Identifiers Names and Codes (LOINC) Committee. Permission is granted in perpetuity, without payment of license fees or royalties, to use, copy, or distribute the LOINC® codes for any commercial or non-commercial purpose, subject to the terms under the license agreement found at https://loinc.org/license/. Additional information regarding LOINC® codes can be found at LOINC.org, including the LOINC Manual, which can be downloaded at LOINC.org/downloads/files/LOINCManual.pdf